RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

Image
Available: Out of Stock
$6.30 USD
RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm CableFeatures:

- It using 22AWG wire, the copper wire inside is very thick, can be resistant to current 2A, 300V voltage.
- IAn insulating layer over a wide range of temperatures, up to 80 degrees. 
- IIt is the common connection of thin copper wire cannot match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.
- IBoard Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
- ICable Length: Approx. 70 cm / 27.56 inch

Connection Description:

- IRed line connecting VCC (ramps of +)
- IConnect the black wire GND (ramps of -)
- IGreen Line connection SIGNAL (ramps in s)

Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.

Package Included:

1 x 3D Printer Endstop Switch




RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm CableFeatures:

- It using 22AWG wire, the copper wire inside is very thick, can be resistant to current 2A, 300V voltage. - IAn insulating layer over a wide range of temperatures, up to 80 degrees.  - IIt is the common connection of thin copper wire cannot match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug. - IBoard Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch - ICable Length: Approx. 70 cm / 27.56 inch
Connection Description:

- IRed line connecting VCC (ramps of +)
- IConnect the black wire GND (ramps of -)
- IGreen Line connection SIGNAL (ramps in s)

Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.

Package Included:

1 x 3D Printer Endstop Switch